BECE June 2017 BDT Home Economics Paper 1: Objective Revision Sprint 7 Sections26 Lessons11 QuizzesLifetime
How Paper 1 Works and How to Pace Yourself
Welcome: this is your paper
This course is built on one real paper: the BECE June 2017 Basic Design and Technology (Home Economics) Paper 1, the objective test. Every lesson, drill and mock in the course follows the way that paper was set. In this first lesson you will see how the paper is built, how long you have, and how to plan your time so that you finish all 30 questions calmly.
The shape of the paper
The cover of the June 2017 paper reads “Basic Design and Technology 1 (Home Economics 1), Objective Test, 40 minutes“. Inside are 30 questions, each with four options lettered A to D. Only one option is correct, you answer all 30, and each question carries one mark.
The paper has two halves, although they are not labelled:
- Q1 to Q15: the BDT core. The same fifteen questions were printed on the Pre-Technical Skills paper too. They mix design and drawing (a principle of design, preliminary designs, a figure pair, motifs, a protractor, design analysis, the tee-square, lettering) with plantain and meat cookery, a tape measure, an electrical repair, weak furniture and crossway strips.
- Q16 to Q30: the Home Economics option. Fastenings, a shirt sleeve, a shirt pocket, attaching a collar, the French seam, darning, freehand cutting, canned food, leafy vegetables, the cover on a table, batter, preservation, bread flour, a garnish and white fish.
This course sorts all 30 questions into four themes by what they test, not by where they sit on the paper:
| Theme (course section) | June 2017 questions | How many |
|---|---|---|
| Design, Drawing, Colour and Enterprise | Q4, Q5, Q6, Q7, Q8, Q9, Q10, Q13, Q14 | 9 |
| Food and Nutrition: Nutrients, Meals and Table Service | Q23, Q25, Q29, Q30 | 4 |
| Food Preparation, Preservation, Kitchen Care and Home Safety | Q1, Q2, Q11, Q12, Q24, Q26, Q27, Q28 | 8 |
| Clothing and Textiles: Fibres, Tools, Stitches and Garment Making | Q3, Q15, Q16, Q17, Q18, Q19, Q20, Q21, Q22 | 9 |
Look at the last row. Nine of the 30 marks are clothing marks, and six of them come in a row (Q16 to Q22) about making a shirt or a uniform. The 2017 Chief Examiner found candidates’ knowledge of Clothing and Textiles “poor”. In Paper 1 you cannot skip it: those nine marks are on the sheet whether you revised them or not.
Three questions with more than one right answer
Three questions get special treatment in this course, because more than one option can be defended with good reasons:
- Q1 (ripe plantain for sale): WAEC’s sheet says grilling, but Ghanaians and the textbooks call the same roadside plantain roasted.
- Q2 (shortening the cooking time of meat): cutting across the grain helps, but so do small pieces and thin slices.
- Q30 (a white fish): cod is the textbook answer, but tilapia also has lean, white flesh.
We teach all three fully in the walkthroughs but do not score them. That is why the past-question replays hold 27 questions, not 30.
One key the answer sheet got wrong
The answer sheet that circulates with this paper gives B, “Grilled chicken”, for Q29 (the dish garnished with lemon and parsley). The correct answer is A, grilled mackerel: lemon and parsley are the classic garnish for fish. The same sheet then prints “Grilled chicken” again beside Q30, where option B is actually Cod; the letter is right but the words were copied down by mistake. If a friend’s sheet disagrees with this course on Q29, trust the reasoning, not the sheet.
The kinds of question you will meet
- Direct facts (most of the paper). One fact, one answer: “Angles are measured by using a” (Q9), “The tee-square is used for drawing” (Q13).
- NOT questions. Q12 asks which option is not a cause of weakness in furniture. Three options are causes; you want the odd one out.
- “Best”, “most” and “most suitable” questions. Q16, Q18, Q20, Q23 and Q28. Several options may work a little; choose the one the textbook names for that exact job.
- Unfinished sentences. Q2 and Q24 begin with “To…” or “In order to…” and the options finish the sentence. Read the stem and each option together as one sentence.
- A figure pair. Q6 and Q7 share Figure 1, a block with a raised centre and a notch underneath. Answer both while the drawing is fresh in your mind.
How much time do you have?
Forty minutes for 30 questions is about 1 minute 20 seconds a question. Most items are one-line facts that take 30 to 50 seconds, so you will have time to spare for the figure pair and a review. Use this plan:
| Clock | Where you should be |
|---|---|
| 10 minutes | Finished Q10, including the figure pair Q6 and Q7 |
| 20 minutes | Finished Q20 |
| 30 minutes | Finished Q30 (first pass done) |
| 30 to 37 minutes | Go back to every question you marked with a small dot |
| Last 3 minutes | Check that every number on the answer sheet has exactly one shaded space |
Rules for the first pass
- If a question takes more than a minute, choose your best option, put a small dot beside its number on the question paper, and move on.
- Never leave a space blank. A blank scores nothing; a careful guess may score.
- Shade in pencil, one space per question. If you change your mind, rub out the first mark completely.
- If the answer sheet shows a space for E, leave it empty. This paper uses only A to D.
How to use this course
- Take the Diagnostic Check at the end of this section. It shows which theme to start with.
- Work through each theme: what was tested, the key facts, the walkthrough of every June 2017 question, the traps, then the Drill and the Past-Question Replay.
- Finish with the Course Assignment and the full 30-question, 40-minute mock in the Final Sprint.
Keep a small notebook of exact terms in pairs: proportion and scale, motif and pattern, protractor and set square, function and ergonomics, italics and Gothic, darning and patching, plain batter and bread dough, soft flour and strong flour. Paper 1 rewards the precise word. Read the list the night before the exam.
